3
SimpliFire • SF-INS25, SF-INS30, SF-INS35 Service Manual • 2042-960 • 3/21
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching.
2. Remove front. Refer to Front Replacement section
for details.
3. Remove glass. Refer to Glass Replacement section
for details.
4. Locate rubber plugs in each end of the grate.
Remove plugs with a small flat screwdriver. Save for
later use. See Figure 3.
5. Remove Phillips screw from each end of grate. Lift
grate from faux ember bed. Take care to retain
screws for grate. See Figure 3.
6. Grasp log ember bed and gently slide, tip and rotate
forward up and out of opening; do not pull too far as
to damage the wiring. Rotate ember bed to expose
electrical wiring.
7. Disconnect lighting LED power source pin connector
from back side of ember bed by gently pulling on
connector. Do not pull on wires. See Figure 4.
8. Reconnect lighting LED power source pin connector
to back side of replacement ember bed. Position the
log assembly. See Figure 4.
9. Rotate log ember bed and align with floor of opening.
Engage back side of ember bed into the opening.
Pivot the front of the ember bed into position flat on
the floor of the opening. Take care not to pinch wiring
under log ember bed.
10. Align the grate over the steel brackets under the
ember bed. Ensure that wiring is not pinched
between log ember bed and steel bracket. See
Figure 3.
11. Install and tighten the screw in each end of the
grate. See Figure 3.
12. Install rubber plugs into holes in each end of grate.
See Figure 3.
13. Re-install glass.
14. Re-install front.
Log/Grate Assembly Replacement
(LOG-INS
**
)
Figure 3 Grate and Log Screw Location
Figure 4 Light LED Connection on Bottom of Log Ember Bed
LED POWER SOURCE PIN
