Simplex 4100ES-S1, Руководство по программированию

Страница: 33 / 118

Document: LT0400 4100ES-S1 Programming Guide
Addressable Device Settings
6-3
6.2.4 4098-9754E Multi-Sensor Photo Heat Detector (COMBO)
Mx-x-0 Parent Point
Device Type
COMBO
– Standard Multi-Sensor detector on standard base
ICOMBO
– Standard Multi-Sensor detector on Isolator base
SCOMBO
– Standard Multi-Sensor detector on Sounder base
Mx-x-1 1
st
Sub Point
Device Type
MPHOTO
– Standard setting
Point Type
– Photo Part
SMOKE
– Standard setting
VSMOKE
– Verified Smoke Detector (Recommended setting to reduce nuisance
alarms)
DUCT
– Duct detector
Mx-x-2 2
nd
Sub Point
Device Type
MHEAT
– Standard setting
Point Type
– Heat Part
MHEAT
– Standard setting
MOHEAT
– Standard heat detector with Rate of Rise
Mx-x-3 3
rd
Sub Point
Device Type
MARCOR
WARNING: DO NOT USE THIS SETTING SINCE THIS IS NOT
APPROVED IN AUSTRALIA
– USE MAOFF INSTEAD
MAOFF
– Choose this setting for Australian use.
Point Type
– R-Correlation Part
UTILITY
– Standard setting for MAOFF
6.3 Addressable Device Settings
Any unused points should be set as utility to avoid potential false alarms from unused fire
point type inputs.
6.3.1 4099-9032 MCP
Device Type
KACPULL
– Standard MCP
Point Type
PULL
– Standard setting
6.3.2 4090-9001/4090-9051 Supervised Input IAM
The 4090-9051 is an encapsulated version of the 4090-9001, with wire leads instead of
terminals. Programming and performance are identical.
Device Type
IAM
– Standard setting
Point Type
FIRE
– General Fire Point.
UTILITY
– Input used by Custom Control Logic only
TROUBLE
– Input used to indicate a Fault status