Expansion Signal (XSIG) Card
Installation Instructions
2005,-2011 SimplexGrinnell LP. All rights reserved.
Specifications and other information shown were current as of publication and are subject to change without notice.
Simplex and the Simplex logo are trademarks of Tyco International Ltd. and its affiliates and are used under license.
579-516
Rev. E
This publication describes the installation procedure for the Expansion Signal (XSIG) Card
(4100-5116).
This product is compatible with 4100U and 4100ES Fire Alarm Control Panels (FACP).
IMPORTANT:
Verify FACP System Programmer, Executive, and Slave Software
compatibility when installing, or replacing system components. Refer to
the Technical Support Information and Downloads website for
compatibility information..
This publication discusses the following topics:
Topic
See Page
Cautions, Warnings, and Regulatory Information
2
Introduction to the Expansion Signal
Card 3
Installing the Expansion Signal Card onto the
PDI 6
Card Configuration
7
Wiring 9
Troubleshooting 16
Introduction
In this Publication
firealarmresources.com
