Simex SLN-94, Руководство пользователя

Страница: 28 / 44

User manual - COUNTER SLN-94
”mAn” - enables manual initialisation of the cycle using button [ESC/RESET] on the
counter front panel. This operation requires confirmation by [ENTER] button. In this
mode clearing by control input { D } is unavailable;
”EL”
- allows activation of additional control input {
D
}. Delivering of active state to this
input causes initialisation of the cycle. Active state on this input must stay at least
10 ms. In this mode clearing by
[ESC/RESET]
button is unavailable;
”no” - this option disables both manual and electronic reset.
It is possible to clear the counter via RS-485 interface, by writing value 000h to
some registers. This method of clearing is available regardless of selected value of
parameter ”
rES ”.
7.3.3. “Ar” parameter
This parameter enables AUTORESET , and allows automatic initialisation of next cycle,
loading the starting value to the counter (”
000
” or ”
Pr1
” depending on counting direction).
Available settings:
“on” - AUTORESET function is active,
“oFF” - AUTORESET function is inactive.
The change of parameters (except
„Pr1”
) causes that next cycle must be initialised
by user (even if AUTORESET function is active).
7.3.4. “dLy” parameter
This parameter allows to add some delay after moment when counter reach threshold
value to automatic initialisation of the next cycle while AUTORESET function is active
( AUTORESET = '” on ” ). Parameter is expressed in seconds and can be set in range „0.0” to
„99.9”. Detailed description of relays operation principle is showed in chapter
CONTROL OF
THE RELAY OUTPUTS... .
7.3.5. ” mod ” parameter
This parameter defines device principle of operation:
”Std” - the device operates as standard counter, only R1 relay is controlled,
”bAt”
- the device operates as a batcher, both relays are controlled
Principle of the relay operation is described in paragraph CONTROL OF THE RELAY
OUTPUTS... .
7.3.6. ”dir” parameter
This parameter defines direction of counting, after new cycle initialisation:
”UP”
- upcounting , from „
000
”,
”dn” - downcounting, form „ Pr1 ”.
28
i
i