Sima HALCON 120, Оригинальное руководство пользователя

Страница: 30 / 156

ENGLISH
-12-
6.2 BLADE REPLACEMENT
HALCON Power Trowel blades P Fig.15 are made of special material that supports the continuous wear friction with
the concrete, but since this is a highly abrasive material, it will inevitably wear in normal use and it will necessary
replace them every so often.
In order to extend the maximum duration, blades are designed to turn 180 degrees in the horizontal plane, which is
given the option to wear the two edges of the blade.
To get around them or replace them, shall be loosening the screws T, Fig.15 that fix the blades to the hexagonal arms
of the machine and make the corresponding change back to tighten the screws again. In case it is also necessary to
replace the screws, we recommend using DIN 931 M8x40 of 8.8 qualities
7. SOLUTIONS TO MOST FREQUENT ANOMALIES
ANOMALY CAUSE SOLUTION
Low oil level alert is on.
Add oil
Fuel clock closed Open fuel clock
Motor switch in OFF position Turn to ON position
Petrol engine does not start.
Safety handle open Press and nail
Loss of electrical supply
Check the general electrical outlet.
Revise the correct position of the
differential and thermal. Verify perfect
state of extension cable and correct fit
on both extremities.
Electrical motor does not start
Damaged switch Replace
Petrol cable interlocked or loose Revise lever and cable accelerator
Gasoline engine does not accelerate
Engine problems Revise by technician
Interlocked or damaged clutch. Revise and replace if necessary
Damaged belt Replace Blades do not turn with the motor
Reducer interlocked or damaged Replace damaged elements.
Dry concrete rests in the central plate. Clean
Blades irregular worn Change
Loose central plate Tighten sufficiently
Machine bumps on the working
surface
Bended arms Replace.
RAMIRENT