StreamCaster MIMO Radio User Manual
4/30/19
10017C000
Silvus Technologies Confidential
Page
109
5.1.13
MPS (Multi-Position Switch)
Figure 50 Multi-Position Switch
The Multi-Position Switch allows you to change various settings of the radio by using the new
physical switch, no web GUI required (This is not available on all radios).
You must first configure the settings you want to correspond with each switch position. The
“Editing Profile” slider represents which position is currently being edited. “Group Type”
represents the collection of settings that will be applied. Only one
“G
roup Type
”
is active at a
given time. When the MPS switch is turned, the LED light on the radio will quickly flash green.
This means the settings are being applied for this position. When the LED stops quickly flashing,
the settings have been applied.
Position 1 is special. Any time settings are updated from the GUI without using the MPS page (i.e.
Basic Tab, PTT/Audio Tab), position 1 will be updated with those results. The green highlight
shows the current position of the physical switch.
If the radio boots up in position “Z,” MPS will be disabled until the radio is rebooted in another
position.
