Silvercrest SSMC 600 B1, Быстрый старт

Страница: 8 / 97

■ 6
│
GB
│
IE SSMC 600 B1
Setting up
Once all components have been cleaned as described in the section “Cleaning”:
■ Position the appliance so that, …
–
that the mains cable passes through the recess at the rear of the appliance,
–
the power plug is immediately accessible, so that it can be quickly
withdrawn in the event of danger,
–
that it is stable and not liable to slip, and so that the sucker feet can attach
firmly and the appliance cannot tip over due to vibration,
–
that the mains cable is not in the working area and thus does not present
a risk of being inadvertently snagged and tipping the appliance over.
Operation
WARNING!
► The motor switches off automatically as soon as the blender is removed
from the motor block or the lid is opened. In such cases it may be easy to
forget that the machine is still switched on. The motor will then start
unexpectedly as soon as the blender attachment is fitted or the lid is closed
again:
Therefore:
–
Do not insert the power plug into the wall socket until the blender is
filled and mounted with its lid fitted and closed.
–
Before fitting the blender, always check to see that the appliance is
switched off or that the power plug has been removed.
–
Switch the appliance off first, pull the plug out and wait until the motor has
come to a standstill before removing the blender or opening the lid.
Fitting and filling the blender
1) Remove the blender from the motor block in a vertical, upward motion.
2) Remove the lid by rotating it anticlockwise towards position until you can
pull it upwards.
3) Fill the blender to at least to the lowest line of the scale and at most to the
MAX mark.
4) Press the lid firmly down onto the blender. Close the lid by turning it clockwise
to position until it audibly engages. Ensure that the pouring spout on the
blender is closed. The motor cannot start until the lid is fitted flush.
5) Press the measuring cap into the lid as far as the stop.
6) Place the completely filled and closed blender with the handle to the
right on the motor block. Make sure that the arrow T on the blender points
to the S arrow on the motor block. Turn the blender slightly back and forth
if it does not immediately sit properly. The motor cannot start until the blender
is fitted flush to the motor unit.
IB_360503_SSMC600B1_LB8-short.indb 6 04.03.2021 13:51:00