GB
│
MT
│
81
■
SDGS 1630 A1
Assembly
1) Unscrew and remove the fixing screw
e
from the telescopic shaft
q
, which is
located on the appliance base
z
(fig . A) .
2) Hold the telescopic shaft
q
so that the power cable retainer
8
is on the
left side . Check if the three locking clips
6
on the telescopic shaft
q
are
unlocked (fig . B) .
3) Insert the telescopic shaft
q
into the appliance base
z
and press it down
until the holes of the telescopic shaft
q
and the appliance base
z
are at the
same level . Reinsert the fixing screw
e
(fig . C) . If the holes are not flush, slide
the telescopic shaft
q
up or down slightly until the holes are aligned with
each other .
4) Screw the fixing screw
e
of the telescopic shaft
q
back into the shaft fully,
so that the telescopic shaft
q
is firmly attached to the appliance base
z
(fig . D) .
5) Insert the integrated clothes hanger
3
vertically into the top of the telescopic
shaft
q
and lock the clip on the integrated clothes hanger
3
(fig . E) .
6) Adjust the telescopic shaft
q
to the maximum height by pulling it upwards
and locking the locking clips
6
(fig . F and G) .
7) Attach the steam head
1
to the steam head mount
2
(fig . H) .
A
B
C
D
