- 8 -
For the sound transmissions use, if neces-
sary, the AUDIO adapter 3,5 mm jack on
CINCH sockets
2$
, which you connect to
the output of the sound card if this has
no cinch output. The yellow plug of the
CINCH—3,5mm jack cable
2)
you con-
nect to the video card's video output.
Tips:
The video card must have an FBAS
output available.
Make sure that the computer is cor-
rectly configured for outputting video
on the video card.
Connecting the receiver
Connect the Audio/Video CINCH out-
•
puts
h
of the receiver
d
to the A/V in-
puts on the target device, probably a
television set. For this you use the sup-
plied three core CINCH cable
2%
. If
necessary, with the aid of the supplied
SCART—CINCH adapter "IN"
2!
.
Note:
Be sure to match the colours correctly.
Insert the cable plug of the second
•
supplied wall plug transformer
1(
into
the connection socket for the supply
voltage
j
.
Insert the wall plug transformer
•
1(
into
a properly connected 230 V~/ 50 Hz
mains power socket.
Important!
Try, if required, to operate the receiver
d
in various locations to avoid cancella-
tion effects and interference and thus
improve the transmission quality.
Switching on
Move the ON/OFF switch
•
a
and
k
of the transmitter and receiver to the
"ON" position to switch them both on.
Switch the signal source on and, if
•
necessary, start playback.
Switch the TV (target device) on and
•
activate
the
A/V inputs to which you
have connected the receiver.
Select on the transmitter and on the
•
receiver, via the CHANNEL switch
s
and
l
, implicitly
in each case the
same transmission channel. The radio
transmission should now function.
Note:
The data/signals sent from the transmit-
ter are not encrypted. This means that
compatible devices within the recep-
tion range are capable of eavesdrop-
ping on the signal. The radio transmis-
sion set uses an "open standard".
To switch the signal source AV 1 and/
•
or 2 for a TV connected to the trans-
mitter
q
press the button "ROOM 1"
e
(= the room in which the transmitter is
located).
To switch the signal source AV 1 and/
•
or 2 for a TV connected to the
receiver
d
press the button "ROOM 2"
r
(= the room in which the receiver is
located).
Point the remote control of the signal
•
source to the infrared receiver
f
of
the receiver
d
. The commands are
sent to your signal source.
IB_KH2130_DT35269_LB4BC.indb 8
IB_KH2130_DT35269_LB4BC.indb 8
04.09.2009 13:10:07 Uhr
04.09.2009 13:10:07 Uhr