Silva Japa 315+, Руководство пользователя

Страница: 15 / 40

japa
315+
User manual
Translation 9 315+ 2.0 - 2020
2.3.2 Installation of the light panel (accessory)
For transport on roads, the firewood processor must be equipped with a light panel. The light panel
pivots, which makes it easy to place in the working position.
Attach the light panel under the motor bed with
two bolts. Insert the wiring harness into the tow
bar starting from the tow coupling. Position the
wires in such a way that they do not hang too low
and the light panel can be turned to its extremes
without the wires restricting it.
Ensure that the turning signal lights work for the
intended directions. If necessary, swap the wires
to the lights to correct the directions.
2.4 Working position
Once you have transported the device to the working location, you can begin placing it in the working
position. Ensure that the foundations are level and the support legs stand firmly on the ground. In
ROAD models, turn the light panel out from under the conveyor.
A. Light panel
B. Front legs
C. Rear legs
D. Open the latch to lower the in-feed conveyor
E. Lower the in-feed conveyor extension
The 3.8 m conveyor is installed in two phases. First, lower the conveyor and fold it open. Then, winch it into
the working position. The 2.3 m conveyor is installed in the working position by removing the support leg