11
Trouble Shooting
Problem
Door not shut properly
Exhaust vent is obstructed
Recently added a large
quantity of warm beverages
to the cabinet
same time. Attempt to stagger the
Condensation on the
High humidity conditions
Door not shut properly
too High
or opened excessively
the cabinet. Open the doors only as
or opened excessively
the cabinet. Open the door only as
No Power
Cabinet Temperature
Temperature setting
Adjust if neccessary
needed and for short periods of time
front mounted exhausting vent
load introduction if possible
cabinet and/or doors
in the home
humidity conditions return to normal
needed and for short periods of time
Occasionally, a problem is minor and a service call may not be necessary - use this trouble
shooting guide for a possible solution. If the unit continues to operate improperly, call an
authorized service depot or toll free at
1-844-455-6097
Possible Cause
What to do
A fuse in your home may be
blown or the circuit breaker
tripped
Replace fuse or reset circuit breaker
Power surge
Unplug the beverage center, wait a few
seconds and then plug it back in
Plug not fully inserted into
wall outlet
Make sure the 3-prong plug is fully
inserted into outlet
Verify the temperature control setting
Ensure that the door is fully closed
and that the gasket is sealing against
Verify there is nothing blocking the
Limit the quantity of warm beverages
being introduced to the cabinet at the
The condensation will subside once
Ensure that the door is fully closed
and that the gasket is sealing against
Alarm beeping and
“HI” is displayed on
the control panel
Recently added a large
quantity of warm bottles or
cant to the cabinet
Limit the quantity of warm items being
introduced to the cabinet
The door is not closed tightly
Be sure the door is closed tightly
System leak, Evaporator fan
failure, compressor fan failure
Contact service center.
To stop beeping, unplug the unit.
Alarm beeping and
“LO” is displayed in
the control panel
Sensor failure, Evaporator
temperature too low
Contact service center.
To stop beeping, unplug the unit
