20
140-00217-100
8.
Flash Firmware
1. Confirm
3.3V Power Supply
and
JTAG
is enabled (See Section 6 above.)
2. Connect
USB1 and USB2 port of EVK board
to
Host PC
with
USB cables
(if you didn’t connect
EVK
board.)
3. From Eclipse IDE top menu, click
Run > External Tools > 1 OpenOCD JTAG Flashing
.
4. Wait until you see
Flash Operation Completed Successfully…
message on
Console
.
9.
Run Firmware
1. Confirm
3.3V Power Supply
and
Debug UART
is enabled (See Section 6 above.)
2. Unplug
USB cable
from
USB1 port of EVK board
(if you connected EVK board.)
3. Remove jumper cable from
J102 Pin 2 - J106 Pin 1
to bootup EVK board in
Autoboot mode
.
4. Connect USB cable to
USB1 port of EVK board
.
5. On
Host PC
, open
USB2 port
with console emulator. Baud Rate 115200 bps, Data 8bit, Parity
none, Stop Bit 1 bit, and Flow Control none.
6. Connect
USB1 port of EVK board
and you’ll see
Command List
on console emulator.
