SILENT KNIGHT IFP-2000, Инструкция по установке и эксплуатации

Страница: 189 / 238

System Operation
151430 10-15
10.7 Releasing Operations
This control panel supports two types of releasing, Double Interlock Zone, and Single
Interlock Zone. The Double Interlock Zone operation requires an interlock switch input in the
system, and the Single Interlock does not. An interlock switch is typically a dry-contact
pressure switch.
When a Single or Double Interlock Zone releasing is selected the system is will automatically
default the following system parameters:
Note: The defaults created can be modified through programming if desired.
• Output Group 2 is created. Output Group 2 will be defaulted as an “Alarm” output group
for all releasing zones. NAC [98:001] is assigned to Output Group 2.
• Output Group 3 is created. Output Group 3 will be defaulted as an “Pre-Alert” output
group for all releasing zones. NAC [98:002] is assigned to Output Group 3.
• Output Group 4 is created. Output Group 4 will be defaulted as a “Release” output group
for all releasing zones. NAC circuit [98:003] is assigned to Output Group 4.
Note: The installer must define which input points will be used for detectors, manual release switches, or inter-
lock/pressure switches
Table 10-2 Approved Releasing Solenoids.
Figure 10-4 Wiring Configuration for Solenoid
Manufacturer Part Number Rating Current Freq
Asco T8210A107 24 VDC 3A max 0 Hz
8210G207 24 VDC 3A max 0 Hz
Model 7641
Must be Mounted
at the Solenoid
Releasing solenoid
Use 24 VDC, UL listed model in table 10-2
1 solenoid per circuit