EtherHaul™ 8000 Installation, Operation and Maintenance Manual
Page 59
6.3.5
Configuration Management
Figure 6-7 System Page: Maintenance
– Configuration Management
This section allows configuring the following parameters:
Default Configuration – Click
Restore
to delete current startup-
configuration.txt file. After reboot, the system will come up with the factory
default configuration (unless customer_default_config.txt file is present).
Startup Configuration – Click
Show
to view (pop-up screen) the startup-
configuration.txt file. The startup-configuration file lists the commands that
build the configuration the system will come up with after reboot.
Click
Load
to load a new startup-configuration file that will replace the current
file and will be used after next system reboot.
When clicking
Load
, the system will look for a file named startup-
configuration.txt at the FTP directory and will store it in the file system (flash:)
as the new startup-configuration file. After next reboot, the system will come up
with the new configuration.
6.4
Event Configuration
Figure 6-8 Network Page: Event Configuration
The system supports masking of individual/group alarms and events. In case alarm is
masked, it is not displayed in the Active Alarms and Event Log and no trap is sent.
