EtherHaul™ 8000 Installation, Operation and Maintenance Manual
Page 49
active port (if both 10GE inputs are available, radio will choose to use the RJ45
10GE input).
Port Enable – checkbox to enable the port.
Disable ports that are not in use so alarm will not be active (link down alarm).
Auto Negotiation – checkbox to enable auto-neg.
Speed/Duplex – speed (10/100/1000/10000) and duplex (half/full) setting:
o
When Auto Negotiation Enabled – R/O field indicating the current
speed/duplex.
For the 10GE combo port, in case port type is set to ‘Auto’, the speed/duplex
displayed will be for the active port.
o
When Auto Negotiation Disabled – manual configuration of the speed and
duplex
1GE port: 10HD, 10FD, 100HD, 100FD, 1000HD or 1000FD
10GE RJ45 port: 100HD, 100FD, 1000HD, 1000FD, 2500FD, 5000FD,
10000FD
10GE SFP+ port: 10000XFD.
Tx and Rx Throughput (Mbits/sec) – last second throughput
Port status – Up or Down.
Note that for the 10GE combo port, ther status refer to either ‘Active’ pr
‘Passive’ ports (based on the port configuration option (RJ45, SFP+ or Auto).
5.2
Advanced Settings
Figure 5-2 Eth Ports Page: Advanced Settings
This section allows configuring the following parameters:
MTU – R/O field indicating the Maximum Transmission Unit of the port.
10,240 bytes.
Alias – text field