3.1.7
Synthesiser
The synthesiser function is used:
•
to store up to 100 transmission values in permanent memory,
•
to recall and transmit the contents of these memories manually or automatically.
When this mode is active the
icon appears in the transmission window.
The
key is used to launch generation of values in in-
creasing order and the
function key is used to launch
generation of values in decreasing order.
The default parameters of this mode are displayed on the
left hand side of the transmission window. To change
these parameters, press ENTER or use the
Configura-
tion
Synthesiser …
Parameters…
.
The parameters of the synthesiser mode are:
First point no.:
Number of the first point in a cycle.
Last point no.:
Number of the last point in a cycle.
T:
The duration for which a point is transmitted.
No.: The number of polling cycles.
Delay:
Delay in seconds between launch and transmission
of the first point.
The number of the first point may be higher than that of the last point. All points between the
first and last are generated.
To edit the points to be synthesized, use the
Configura-
tion
Synthesiser…
Points…
Menus.
Use the function keys:
•
to cancel a point.
•
to add a point.
•
to edit a point.
Use the
and
keys to transmit points according to the parameters defined.
