In the case of values predefined as a percentage of full
scale, the
icon appears on the left hand side of the
transmission window.
The
icon indicates setting to scale. To display the
scale applied, use the Configuration menu, then the “set
to scale” menu.
3.1.4
Steps
This mode is used to program an incremental progression of the active transmission func-
tion.
When this mode is active, the
icon appears in the transmission window.
The
function key launches a cycle of increasing in-
crements and the
function key launches a cycle of
decreasing increments.
The default parameters of this mode are displayed on the
left hand side of the transmission window. To change
these parameters, press ENTER or use the
Configura-
tion
Mode…
menus.
The parameters of a staircase are:
L:
Minimum amplitude of the signal.
H: Maximum amplitude of the signal.
I:
Amplitude of the increment.
T:
Duration of the steps in seconds.
Delay:
Delay in seconds between launching the staircase
and transmission of the first increment.
