SIKA Induq VMM Series, Руководство по эксплуатации

Страница: 23 / 56

i ndu Q
®
- Series VMM Operation
Technical changes reserved
- 23 -
Selection window / make a selection:
For the selection window, the first line of the LCD always displays the heading, while the sec-
ond line displays the current setting.
For the selection window, the first line of the LCD always dis-
plays the heading, while the second line displays the current
setting. This setting is shown in square brackets if the system is
in programming mode (

"Operating modes", p. 22).
In Programming mode, i.e. after a password has been entered the operator can navigate to
the desired setting by using the
 key or the  key. The actual selection will be confirmed by
pressing ENTER key.
Pressing the ESC key will discard changes.
Input window / modify a value:
For the input window, the first line of the LCD always shows the heading, while the second
line shows the current setting.
Modifications can only be made in Programming mode (

"Operating modes", p. 22).
To move the flashing cursor from one decimal place to another,
use the

or

keys.
To in-/decrease the value of the decimal place, which is highlighted, by 1, use the

or

key.
To change the minus and plus sign, place the cursor in front of the first digit. To confirm and
apply the change, press the ENTER key.
To discard the changes, press Esc
Passwords:
Programming mode is password protected. Entering the customer password will allow all
changes that are permissible for customers.
This password can be changed when the device is first put into operation. Therefore changes
should be kept in a safe place.
The factory setting for the VMM customer password is: "0002".
The service password allows modification of all functions and parameters. This password is
not given to customers.
Function name
[selection]
Function name
-4.567 Unit