LED Architectural Emergency Light
Universal 120/ 277 VAC Supply
1. Disconnect AC power before servicing.
7. Mount and secure the fixture at a location and height to avoid ready access
2. Refer to wiring diagram for proper connections.
and tampering by unauthorized persons.
3. All servicing should be performed by qualified personnel.
8. The use of accessory equipment is not recommended by the manufacturer
4. Consult your local building code for approved wiring and installation.
and may cause an unsafe condition.
5. Do not use this equipment for other than intended use.
9. Suitable for wet locations. See product label for temperature limitations.
6. Do not let power cords touch hot surfaces.
IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Series MAE-AC
MoonLite LED
INSTALLATION INSTRUCTIONS AND OWNER'S MANUAL
SUITABLE FOR WET LOCATIONS
AMBIENT TEMPERATURE LIMITS:
Standard models: -20º C to +40º C
Remote models: -40º C to +50º C
J- Box and Supply Wiring
1. See above for available K.O.'s for wiring connectors. Select K.O.'s for AC input wiring. Install standard
4” x 4” deep j-box with 1 ½” extension.
IMPORTANT:
SET J-BOX ASSEMBLY TO ALIGN EDGE OF EXTENSION FLUSH OR JUST BELOW
FINISH PANEL SURFACE.
2. See above. Insert Power Supply Assembly (1) into j-box and secure with two #8-32 x ½” screws.
3. See above. Connect AC input wiring from power supply assembly to building supply with wire nuts,
05.10.01
1
(2) # 8-32 x 1/2
J-BOX MOUNT
SCREWS
LAMP PLUG
GROUND
TO J-BOX
L N G
120/277 VAC
B
W
EXTENSION
RING 1 1/2"
J-BOX
4 x 4 x 2 1/8"
AVAILABLE K.O.'S
4 PLACES
SET EDGE OF BOX
FLUSH TO WALL
FINISH OR
PANEL THICKNESS
STANDARD J-BOX
4 x 4 x 21/8"
EXTENSION RING
4 x 4 x 11/2"
