6"
6"
INSIDE HOUSING
MOUNTED FROM
THERMAL PROTECTOR
TRAY SCREW
FACE PLATE
ELECTRICAL TRAY
HOUSING
MOUNTING SCREW
TO REMOVE
(IF SUPPLIED)
REMOVE LAMP
MOUNTING
SCREW
Make sure power is off before installing or servicing this fixture.
Remove face plate by loosening 4 philips screws on front of louver.
Remove electrical tray by loosening one philips screw.
Install housing per instructions on following page, according to specific mounting application: New stud wall,
Existing stud wall, Masonry wall, or concrete pour installation.
For interior or exterior, new or existing walls of plasterboard or wood, a thermal protector is required and insulation
is to be a minimum of 6 inches away from sides of housing. Install thermal protector by removing 1 inch snap-in plug
and pushing protector through hole from inside housing.
Thermal protection is not required for masonry or concrete pour installations. Thermal protection is also not
required for fluorescent lampings since the Recessed Bricklyte ballast is class P and contains thermal protection.
Re-assemble fixture.
Turn power ON.
GFI PROTECTION! Fixtures which may come in contact with or be exposed to moisture (i.e. outdoors) shall be
installed on a GFI (Ground Fault Interruptor) protected circuit.
This system is intended for installation in accordance with the National Electrical Code and local code
specifications.Failure to adhere to these codes and instructions may result in serious injury and/or damage to the
fixture, and will void HADCO's warranty. These instructions cover most installation applications. For any special
applications not covered, please contact HADCO for assistance.
READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING THIS FIXTURE.
32000896, revision
E
INSTALLATION INSTRUCTIONS:
CB100 BRICKLYTE
This fixture is intended for installation in accordance with the National Electrical Code and local code
specifications. Failure to adhere to these codes and instructions may result in serious injury and/or damage
to the ballast and void the warranty. These instructions do not purport to cover all details or variations in
equipment, nor to provide for every possible contingency related to installation, operation, maintenance,
or mounting situation. Should specific problems occur that are not addressed by these instructions, contact
your Sales Representative or distributor for assistance. Retain these instructions for future reference.
page 1 of 3
www.
hadco.
com
Signify North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873, USA
Phone: 855-486-2216
Signify Canada Ldt./ Signify Canada Ltée
281 Hillmount Road
Markham ON, Canada L6C
2S3
Phone: 800-668-9008
