SignaMax SC30010, Справочное руководство CLI

Страница: 75 / 671

Chapter 3
| General Commands
– 75 –
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
This command resets the entire system.
◆
Any combination of reload options may be specified. If the same option is
re-specified, the previous setting will be overwritten.
◆ When the system is restarted, it will always run the Power-On Self-Test. It
will also retain all configuration information stored in non-volatile memory
by the
copy running-config startup-config command (See “copy” on
page 98 ).
Example
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2016 ---
***
Are you sure to reboot the system at the specified time? <y/n>
enable
This command activates Privileged Exec mode. In privileged mode, additional
commands are available, and certain commands display additional
information. See
“Understanding Command Modes” on page 66 .
Syntax
enable [ level ]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec,
15: Privileged Exec. Enter level 15 to access Privileged Exec mode.
Default Setting
Level 15
Command Mode
Normal Exec
Command Usage
◆
“super” is the default password required to change the command mode
from Normal Exec to Privileged Exec. (To set this password, see the
enable password command.)