SignaMax SC30010, Справочное руководство CLI

Страница: 390 / 671

Chapter 13
| Port Mirroring Commands
RSPAN Mirroring Commands
– 390 –
rspan source
Use this command to specify the source port and traffic type to be mirrored
remotely. Use the
no form to disable RSPAN on the specified port, or with a
traffic type keyword to disable mirroring for the specified type.
Syntax
[ no ] rspan session session-id source interface interface-list [ rx | tx
| both ]
session-id – A number identifying this RSPAN session. (Range: 1-3)
Three sessions are allowed, including both local and remote
mirroring, using different VLANs for RSPAN sessions.
interface-list – One or more source ports. Use a hyphen to indicate
a consecutive list of ports or a comma between non-consecutive
ports.
ethernet unit / port
unit - Unit identifier. (Range: Always 1)
port - Port number. (Range: 1-52)
rx - Mirror received packets.
tx - Mirror transmitted packets.
both - Mirror both received and transmitted packets.
Default Setting
Both TX and RX traffic is mirrored
Command Mode
Global Configuration
Command Usage
◆
One or more source ports can be assigned to the same RSPAN session,
either on the same switch or on different switches.
◆ Only ports can be configured as an RSPAN source – static and dynamic
trunks are not allowed.
◆
Only 802.1Q trunk or hybrid (i.e., general use) ports can be configured as
an RSPAN source port – access ports are not allowed (see
switchport
mode ).
◆
The source port and destination port cannot be configured on the same
switch.