SignaMax SC30010, Справочное руководство CLI

Страница: 39 / 671

Chapter 1
| Initial Switch Configuration
Configuring the Switch for Remote Management
– 39 –
Configuring the Switch for Remote Management
Using the Network
Interface
The switch can be managed through the operational network, known as in-
band management. Because in-band management traffic is mixed in with
operational network traffic, it is subject to all of the filtering rules usually
applied to a standard network ports such as ACLs and VLAN tagging. In-band
network management can be accessed via a connection to any network port
(1-52).
Setting an IP
Address
You must establish IP address information for a switch to obtain management
access through the network. This can be done in either of the following ways:
Manual — You have to input the information, including IP address and subnet
mask. If your management station is not in the same IP subnet as the switch,
you will also need to specify the default gateway router. To configure this
device as the default gateway, use the
ip default-gateway command.
◆
Dynamic — The switch can send IPv4 configuration requests to BOOTP
or DHCP address allocation servers on the network, or automatically
generate a unique IPv6 host address based on the local subnet address
prefix received in router advertisement messages. An IPv6 link local
address for use in a local network can also be dynamically generated as
described in
“Obtaining an IPv6 Address” on page 44 .
This switch is designed as a router, and therefore does not support DHCP for
IPv6, so an IPv6 global unicast address for use in a network containing more
than one subnet can only be manually configured as described in
“Assigning an
IPv6 Address” on page 40 .
Manual Configuration
You can manually assign an IP address to the switch. You may also need to
specify a default gateway that resides between this device and management
stations that exist on another network segment. Valid IPv4 addresses consist
of four decimal numbers, 0 to 255, separated by periods. Anything outside this
format will not be accepted by the CLI program.
Note: The default IPv4 address and subnet mask for VLAN 1 is 192.168.2.10
255.255.255.255, with no defined default gateway.