SignaMax SC30010, Справочное руководство CLI

Страница: 112 / 671

Chapter 4
| System Management Commands
Line
– 112 –
Command Usage
The databits command can be used to mask the high bit on input from
devices that generate 7 data bits with parity. If parity is being generated,
specify 7 data bits per character. If no parity is required, specify 8 data bits per
character.
Example
To specify 7 data bits, enter this command:
Console(config-line-console)#databits 7
Console(config-line-console)#
Related Commands
parity (114)
exec-timeout
This command sets the interval that the system waits until user input is
detected. Use the
no form to restore the default.
Syntax
exec-timeout [ seconds ]
no exec-timeout
seconds - Integer that specifies the timeout interval.
(Range: 60 - 65535 seconds; 0: no timeout)
Default Setting
10 minutes
Command Mode
Line Configuration
Command Usage
◆ If user input is detected within the timeout interval, the session is kept
open; otherwise the session is terminated.
◆
This command applies to both the local console and Telnet connections.
◆
The timeout for Telnet cannot be disabled.
◆
Using the command without specifying a timeout restores the default
setting.