Signamax 098-2000SX Gigabit Fiber Ethernet Adapter
10
User’s Manual
Connecting to Your Network
This section describes how to connect the adapter to a fiber wire-
based Gigabit Fiber Ethernet network, which contributes to its
optimal performance.
i
You must connect the adapter to the network before installing the
network driver.
Step 1:
Remove the protective covers from the adapter’s connector.
Step 2:
Prepare a Fiber network cable with corresponding SC connectors
for the two end devices, one end to the adapter and the other to a
SC port on the Gigabit switch.
Step 3:
Connect the fiber cable to the connector on the adapter.
Step 4:
Connect the other end of the network cable to a Gigabit switch.
Step 5:
When the cable is properly connected to the two end devices, turn
on the power to the PC.
Step 6:
Check the LNK/ACT (Link/Activity) LED. The LED will come on
when the adapter is receiving a good link signal from the
connected device.
Step 7:
Proceed to the next section for instructions on installing the
network driver.
