S-DIAS SPLITTER ETHERNET
SE 052
02.08.2019
Page 9
4
Technical Data
4.1
Performance Data
Interfaces
5x Ethernet 10/100 Mbit (Tyco Mini I/O)
4.2
Standard Configuration
Ethernet 1
X1
Ethernet 2
X2
Ethernet 3
X3
Ethernet 4
X4
Ethernet 5
X5
Problems can arise if a control is connected to an IP network, which
contains modules that do not contain a SIGMATEK operating system. With
such devices, Ethernet packets could be sent to the control with such a
high frequency (i.e. broadcasts), that the high interrupt load could cause a
real-time runtime error or runtime error. By configuring the packet filter
(Firewall or Router) accordingly however, it is possible to connect a network
with SIGMATEK hardware to a third-party network without triggering the
error mentioned above.
4.3
Electrical Requirements
Supply voltage
18-30 V DC
UL: Class 2 or LVLC
(1)
Supply current over X6
200 mA
(1)
Limited Voltage/Limited Current
(1)
The device must be connected to a secondary galvanically separated
supply with a rated voltage of 24 V DC. In compliance with UL 249, max 4
A, the fuse must be connected in the area between the supply source and
the end device.
