SIGMATEK HGW 1033, Руководство по эксплуатации

Страница: 69 / 84

WIRELESS HANDHELD OPERATING PANEL HGW 1033-3
11 Transport/Storage
INFORMATION
This device contains sensitive electronics. During transport and storage,
high mechanical stress must therefore be avoided.
For storage and transport, the same values for humidity and vibration as
for operation must be maintained!
Temperature and humidity fluctuations may occur during transport.
Ensure that no moisture condenses in or on the device, by allowing the
device to acclimate to the room temperature while turned off.
CAUTION
The product HGW 1033-3 has an integrated battery. During transport,
observe the applicable national regulations.
Le produit HGW 1033-3 est équipé d'une batterie intégrée. Pendant le
transport, re-specter les réglementations nationales en vigueur.
The product HGW 1033-3 must be set to “Transport Mode” before
shipping.
Le produit HGW 1033-3 doit être réglé sur "Transport Mode" lors de
l'expédition.
As long as it is charging, an HGW 1033-3 cannot be set to transport mode (e.g. connected
to the charging station, USB-C,…)
To set the transport mode, enter the following command in the CLI:
BATTERY TRANSPORTMODE
After entering the “BATTERY TRANSPORTMODE” command in the CLI, the system shuts
down after circa 10 seconds. When the display is off and the power LED no longer blinks,
the transport mode has been successfully activated.
Due to the battery’s self-discharge, we recommend that it be pre-charged to a minimum of
30 % for transport mode. Deep discharge, as well as damage to the battery is thereby
avoided.
03.03.2021 Page 67