SIGMATEK HGW 1033, Руководство по эксплуатации

Страница: 58 / 84

HGW 1033-3 WIRELESS HANDHELD OPERATING PANEL
9.2 Battery/Power Supply
INFORMATION
During the initial start-up, the transport mode is deactivated while
charging the panel. In this case, the operating panel must be charged
for at least the time defined in the table. During which, no parameters
can be called from the battery. During this time, the battery pack is
calibrating.
Do not interrupt this initial charging process, otherwise false battery
parameters may be provided.
HGW HW version Battery wake time
2.00 360 seconds (6 minutes)
starting with 2.10 5 seconds
To charge the HGW 1033-3 for the first time, mount it onto an operational base station.
Charge the HGW 1033-3 either via the base station or using a USB-C supply.
Take into consideration that depending on the quality of the USB-C supply or its
performance, the charging process can take significantly longer. Note the minimum
requirement of 20 V (profile 4) of the external USB supply.
9.3 WLAN Channels and Settings
The WLAN channels and settings supported by the hardware and software can be found in
the "WLAN Configuration" document. Only the channels and settings released there may
be used.
INFORMATION
The information contained in the document "WLAN Configuration" does
not release the user from the obligation to observe national standards
and laws as well as special regional regulations.
Page 56 03.03.2021