SIGMATEK ETT 736, Руководство по эксплуатации

Страница: 45 / 54

TOUCH OPERATING PANEL ETT 736
12.01.2022 Page 43
14.2 Service
This product was constructed for low-maintenance operation.
14.2.1 Calibrating the Touch Screen
The touch screen is calibrated at the factory. You should therefore only recalibrate the touch
screen when press-point changes are noticed.
The calibration can be run either with the following CLI command or via the application (as
long as it is provided by the application engineer).
calib
14.3 Repair
When sent for repair, the panel should be transported in the original packag-
ing if possible. Otherwise packaging should be selected that sufficiently pro-
tects the product from external mechanical influences, such as cardboard
filled with air cushioning.
In the event of a defect/repair, send the panel with a detailed error description to the address
listed at the beginning of this document.