SIGMATEK DIAS-DRIVE 210-23, Руководство пользователя, Страница: 6 / 91

DIAS-DRIVE 210-23
Page 6 30.03.2021
When using a ground fault interrupter in the circuit, a type B FI-switch must
be used. If a type "A" FI-switch of is used, a DC ground fault could cause a
malfunction.
Failure to follow these instructions can lead to death, serious injury or
damage to the machine.
Warning General
The use of the servo amplifier is defined by EN61800-3. In residential areas,
EMI problems can arise. In such a case, the user must take additional filter-
ing measures.
The servo amplifier contains electrostatic-sensitive components, which can
be damaged by improper handling. Before touching the servo amplifier, the
user must discharge their body by touching a grounded object with a conduc-
tive surface. Contact with highly insolated material (synthetic fiber, plastic foil
etc.) must be avoided. The servo amplifier must be placed on a conductive
surface.
The device cannot be opened. During operation, all covers and cabinet doors
must be closed to avoid the danger of death, serious health risks or material
damage.
According to their protection type, servo amplifiers can contain blank com-
ponents that are conductive. Control and power connections can have a volt-
age even when the motor is not turning.
The main voltage supply for the DIAS-Drive requires a fixed connection. If the
servo amplifier is mounted with a connector terminal to a moving machine
part, the earth connection must have a cross section of at least 10 mm
2
(8
AWG) due to the high residual current (>3.5 mA) of the amplifier.
The +24 V auxiliary supply voltage as well as the +24 V-BR voltage supply
for the holding brake must be galvanically separated as PELV according to
EN 60950.
Failure to follow the above safety measures can lead to severe injuries
and machine damage.