SIGMATEK DIAS-DRIVE 210-23, Руководство пользователя, Страница: 54 / 91

DIAS-DRIVE 210-23
Page 54 30.03.2021
7 Brake switch error
─ Defective internal stop
brake switch
─ No stop brake connected
with parameters
M-BRAKE = 1
─ exchange the amplifier
─ Motor used with stop brake
─ Change
M-BRAKE parameter
to 0 as long as a motor without
brakes is used.
─ Check connector and motor
cable
─Check stop brake
8 Reserved
9 Motor temperature
─ Motor temperature switch
is triggered
─ Cable or connector break
in feedback
─ Check cause (Motor too small,
poor environmental conditions)
─ Check feedback cable and
connector, exchange if neces-
sary
10 Ambient tempera-
ture
─ Internal temperature too
high
─ Improve control cabinet ventila-
tion, check mounting position
and compare it with the specifi-
cations of this instructions.
11 Heat sink tempera-
ture
─ Heat sink temperature too
high
─ Improve control cabinet ventila-
tion, check mounting position
and compare it with the specifi-
cations of this instructions
12 Feedback error
─ Feedback cable broken
─ Feedback defective
─ Bad feedback connection ─Check feedback cable and
replace if necessary
─ Exchange feedback
─ Check feedback connection
13
Commutation error
─ Incorrect motor phase
position
─ Incorrect motor connection
or wrong feedback cable
─ Check the
M-ROFF parameter
─ Check motor connection
14 Motor over speed
─ Incorrect motor phase
position
─ Incorrect motor connection
or wrong feedback cable
─ Overshoot (greater than
1.2 * V-NMAX )
─ Check
M-ROFF
─ Check motor connection
─ Check feedback cable
─ Optimize controller circuit
15 Drag error
─ P-PEMAX drag error
window too small
─ Increase P-PEMAX and/or
optimize controller circuit
16 Trajectory error
─ The speed setting, which
was calculated using the
change in the position set
value by the host results in
more than 10000 min
-1
─ Check
P-PSCALE and
P-SSCALE parameters and the
reference value