SIGMATEK DIAS-DRIVE 210-23, Руководство пользователя, Страница: 21 / 91

DIAS-DRIVE 210-23
30.03.2021 Page 21
•
The main supply can under no circumstances exceed the rated values
for the servo amplifier. Attention should be paid to "Different Power
supplies" on page 3029.
•
The external fuse for the main supply, the +24 V auxiliary and holding
brake supply must meet the specifications for "External Fuse" on page
36.
•
The motor and control cable should be laid with a minimum distance
of 100 mm. This improves the effect of noise in the control cable,
which is caused be the high noise generation of the motor cable . A
shielded motor and feedback cable must be used, by which the shield-
ing on both cables is applied.
•
As described on page 32, the correct mounting position is vertical.
•
The ventilation in the control cabinet must provide sufficiently cool and
filtered air. Instructions for the "Environmental Conditions" are found
on page20.
•
Any post-delivery changes made to the servo amplifier, with the ex-
ceptions of parameters, invalidates the warranty.
•
During the initial start-upof the servo amplifier, the peak current must
be tested. Small motors can be damaged quickly, especially if the ser-
vo amplifier settings are too high (i.e. a 1A motor with a 10A amplifier
without being limited to 1A)
•
Note: The symbol for mass , found in all schematic plans, means
that the electric connection between the indicated device and the
mounting panel in your control cabinet must be made over the largest
possible surface. This connection should enable the dissipation of HF
noise and should not be confused with the PE symbol (EN 60204 pro-
tection) (Protective measure according to EN 60204).
•
Shelf life:
< 1 year: no limitations
≥ 1 year:
The intermediate circuit capacitors of the servo amplifier
must be reformed before the initial start up. In addition all electrical
connections must be removed and the servo amplifier supplied with
230 V for 30 minutes, single phase at terminals L1 / L2.