Sigma 1-6P, Руководство по эксплуатации

Страница: 48 / 67

7.2.1 Autoclaving
The service life of the accessories essentially depends on the frequency of
autoclaving and use.
•
Replace the accessories immediately when the parts show changes in color
or structure or in the occurrence of leaks etc.
•
During autoclaving, the caps of the tubes must not be screwed on in order to
avoid the deformation of the tubes.
It cannot be excluded that plastic parts, e.g. lids, may deform during autoclaving.
Autoclaving:
Accessories max. temp.
°C
min. time
min max. time
min max.
cycles
Glass tubes 134-138 3 40 -
Polycarbonate tubes 115-118 30 40 20
Polypropylene tubes 115-118 30 40 30
Teflon tubes 134-138 3 5 100
Aluminum rotors 134-138 3 5 -
Polycarbonate/Polyallomer
lids for angle rotors 115-118 30 40 20
Polysulfone lids for angle
rotors 134-138 3 5 100
Aluminum buckets 134-138 3 5 -
Polycarbonate caps for
buckets 115-118 30 40 50
Polypropylene caps for
buckets 115-118 30 40 50
Polysulfone caps for
buckets 134-138 3 5 100
Rubber adapters 115-118 30 40 -
Rubber cushions 115-118 30 40 -
Round carriers made of
polypropylene 115-118 30 40 -
ditto, made of polyallomer
and polycarbonate 115-118 30 40 -
Rectangular carriers made
of polypropylene 115-118 30 40 -
ditto, made of polyallomer
and polycarbonate 115-118 30 40 -
Fig. 7.1: Autoclaving table
Operating Manual SIGMA 1-6P page 48 of 67
05/2007