Advanced Connections
The NetStream 2000 also includes an internal CD Audio In connec-
tor that allows you to pass MPEG audio through to the internal CD
Audio In connector on your sound card. To do this, attach the CD
Audio cable from your CD-ROM or DVD-ROM drive to the
NetStream 2000, then attach another cable from the NetStream
2000’s internal Line Out port the to the CD Audio In connector on
your sound card. Please refer to Figure 1 for the locations of these
internal connectors.
The signal from the Line Out port combines the CD Audio In signal
from the CD-ROM or DVD-ROM drive with the same signal that is
output through the Stereo Output Port on the NetStream 2000. This
solution eliminates the external audio cable that normally goes from
the NetStream 2000 to your sound card.
If you are using this solution, attach your receiver or amplified
speakers to the Line Out port of your sound card to obtain the audio
sound signal.
Note: With this solution, the volume for both CD audio and MPEG
audio will be controlled by the CD Audio portion of your mixer.
Note: For the best playback quality, make sure the NetStream 2000
is connected directly to a TV, not through a VCR.
Macrovision Copyright Notice
This product incorporates copyright protection technology that is
protected by method claims of certain U.S. patents and other intel-
lectual property rights owned by Macrovision Corporation and other
rights owners. Use of this copyright protection technology must be
authorized by Macrovision Corporation, and is intended for home
and other limited viewing uses only, unless otherwise authorized by
Macrovision Corporation. Reverse engineering or disassembly is
prohibited.
Chapter 2: Hardware Installation 9
NetStream 2000 Manual 6.6.2000 6/6/00 2:47 PM Page 14
