SSG5000A RF Signal Generator User Manua
l
21 SSG5000A User Manual
Level setting
Setting the RF signal level
1. Keypad operation:
Press the
LEVEL
->
Level
to make the focus fall on this parameter item
⚫
Use the numeric keypad to input the desired value and press the unit button to select
the desired unit. Optional units are dBm, dBuV, uV, mV, V, nW, uW and mW. Press
ENTER
to select the current unit by default.
⚫
Press
ENTER
or press the knob to enter the parameter editing state, and then use
the left and right direction keys to move the cursor to the desired position. Press the
up and down direction keys, rotate the knob or press the numeric keypad to modify
the value. Press
ENTER
, knob or
ESC
to exit the editing mode.
2. Touch screen operation
Click on
RF
->
LEVEL
->
Level
to enter the interface of RF output level setting.
⚫
Click the level parameter to pop up the keypad interface, and then click the number
symbol in the keypad to change the value. Click the unit to modify the unit. Click the
check mark to confirm the modified value and selected unit.
Level Offset
Setting the level offset from the RF signal’s level
Application: When connecting a fixed attenuation or gain, the level value after attenuation
or amplification can be directly read and set on the RF source by setting a level offset.
When level offset is not zero, the status bar will display OFFSET in blue.
1. Keypad operation
Press
LEVEL
->
Level Offset
to make the focus fall on this parameter item.
⚫
Use the numeric keypad to input the desired value. Press
ENTER
or click the check
