SIGLENT TECHNOLOGIES SDS2000X-E Series, Руководство пользователя, Страница: 109 / 222

SIG L ENT
SDS2000X-E User Manual
83
I2C Trigger and Serial Decode
Please read “ Setup for I2C Signals ”, “ I2C Trigger ” and “ I2C Serial Decode ” to trigger
and decode the signals.
Setup for I2C Signals
Setting the I2C (Inter-IC bus) signal includes two steps: connecting the serial data signal
(SDA) and serial clock signal (SCL) to oscilloscope, specifying the threshold voltage of
each input signal.
1. Press Decode key to enter the DECODE function menu as Figure 35 shows.
Figure 35 I2C DECODE Menu
2. Press the Decode softkey and select the desired slot (Decode1 or Decode2).
3. Press Protocol softkey and then select I2C by turning Universal Knob .
4. Press Signal softkey to enter the SIGNAL menu as Figure 36 shows.
Figure 36 I2C SIGNAL Menu
5. Set SCL (I2C’s clock signal):
a. Press SCL softkey to select the channel that is connected to the I2C clock signal.
b. Press first Threshold softkey to set the I2C clock signal’s threshold voltage level
by Universal Knob . The threshold voltage level is for decoding, and it will be
regard as the trigger voltage level when set the trigger type to serial.
6. Set SDA (I2C’s data signal):
a. Press SDA to select the channel that is connected to the I2C data signal.
b. Press second Threshold softkey to set the I2C data signal’s threshold voltage
level by
Universal Knob
. The threshold voltage level is for decoding, and it will
be regard as the trigger voltage level when set the trigger type to serial.
(Tip: SDA should keep stable during the whole high clock cycle, otherwise it will be
interpreted as a start or stop condition (data transitioning while the clock is high).)
7. Press softkey to return previous menu.