GENERAL INFORMATION
All of the parts on the plan are identified by a number or a letter.
Parts identified by a number are laser cut parts.
Parts identified by a letter are stripwood pieces that you cut and fit on assembly.
The slight discoloration of the edges of the laser cut parts may be removed by lightly sanding them with 400 grit
sandpaper.
Your kit contains the following parts. Please check your kit for any missing or damaged parts before starting construction.
COMPLETE KIT PARTS LIST
1 Plan Sheet #1
1
Decal Sheet
2
Gray Tissue
2 Wire Axle
1
Tail Wheel Assembly
1
100" Thread
1 Windshield Material
25
1/16"sq.x18" Balsa Strip
10
3/32"sq.x18" Balsa Strip
2 1/8"sq.x18" Balsa Stripp
2
3/32"x1/4"x18" Balsa Strip
1
3/16"x1 3/4" Dowel
1 Instruction Manual
1
Plastic Propeller
1
Propeller Shaft
2 Brass Thrust Washers
1
Plastic Propeller Bearing
1
Balsa Block for Spinner
2 Plastic Wheels
1
3/16"x60" Rubber Strip
14
Laser Cut Sheets
Tools and Building Supplies
You will need the following items to assemble this model. You must read and follow all of the manufactures
instructions provided with these items!
-Glue
CA, White Glue, Sigment or Ambroid all work well.
-Cutting Tools
A single edge razor blade or a hobby knife with a #11 blade
can be used for all of the cutting.
-Clear Dope, Thinner & paint brush
-200, 320 and 400 sandpaper
-Straight Pins
-Wax Paper
-Needle nose pliers
-Crayon or Candle
-1/4", 1/16" and 1/32" Drill Bits
-Building Board
Содержание Ryan S-T
Страница 3: ... ...
