Configuration Settings
Rev 4 May.17
85
•
Maximum Report Interval
: the maximum amount time to elapse after which
a throughput event is generated when the defined threshold has not been
reached. The default is 900 seconds (15 minutes).
•
Threshold
: events are generated once this threshold is reached and the
Minimum Report Interval has passed. If a threshold has not been reached
before the Maximum Report Interval has elapsed, then an event will be sent
when that interval elapses. The default threshold is 1,024 KB (1 MB).
•
Monitored Ports
: the ports to be monitored. The default is port 80. Other
ports can be added by separating with commas.
A.8 WAN Recovery Settings
•
WAN Link Recovery
: when enabled, the oMG will use the following two
parameters to reboot the oMG to try to establish a WAN link.
•
Reboot System After
: this timer sets the amount of time (in seconds) that
the oMG waits after losing a WAN connection to automatically reboot.
•
Remote Configuration WAN Recovery
: if enabled, the oMG will discard
configuration changes that have been pushed by the AMM that result in the
oMG losing WAN connectivity.
•
Restore previous configuration after
: the amount of time (in seconds) that
an oMG will keep new configuration parameters pushed by the AMM that
result in losing WAN connectivity. If the oMG has no WAN connectivity after
the timer expires, the oMG will revert to the original configuration.
A.9 VPN Configuration Settings
•
Friendly Name
: enter a descriptive nickname for the VPN.
•
Server Address
: set to the VPN Gateway IP Address (IP address or FQDN)
•
Server ID
: the IP address, hostname, domain name, or fully qualified domain
name that the VPN server will use to identify itself to the gateway while
negotiating the VPN tunnel. The value should be provided by the VPN server
administrator. If left blank, the gateway will assume that the IP address of the
server (set in Server Address) is the same as the Server ID.
•
Remote Network
:
·
Remote Subnets
: set to the destination IP network and destination IP
network mask in CIDR notation.
·
Allow Management Tunnel Bypass
: set to enabled. Sierra Wireless
strongly recommends this field be enabled. Although it necessitates
planning for the management tunnel UDP connection through to the
AMM, the benefit is that it allows for an independent means of access to
the oMG from the AMM for remote configuration and troubleshooting.
·
IPSec Full Tunnel Address Exemptions
: traffic generated on the oMG
to the IP addresses (or FQDN's) defined in this list will not be sent
through the IPsec VPN tunnel (where the list is included).
•
Local Termination
: options are Network and Host. Network is used when the
termination is a network. Host is used for host to LAN configuration.