Sierra Wireless oMG series, Руководство по эксплуатации и настройке, Страница: 84 / 101

Operation and Configuration Guide 3.14
84 4118618
SSH, command line) while at the same time, allows access to required
resources such as DNS and proxy.
• Isolated : when checked, the LAN segment is isolated and no other segments
can see it. However, the isolated LAN segment can see the others.
A.6.3 VLAN Settings
• Enabled : when enabled, allows for a VLAN to be configured.
• Add VID : adds a VLAN ID number.
• Remove VID : removes the VLAN ID selected in the list to the left of the
button.
A.6.4 LAN Ethernet 802.1x Settings
• Primary 802.1x retry interval : the time, in seconds, after which the system
will retry the primary host after failing over to the secondary host. The default
is set to send to the secondary only if the primary fails.
• Interim 802.1x accounting interval : the frequency (in seconds) at which the
system will send interim accounting data, which would otherwise be sent only
at the start and stop of a login session (and could therefore be lost if the
network connection was lost). Set to 0 to disable.
• Enable EAP Re-authentication Period : when enabled, this setting causes
the connection to renegotiate its connection credentials periodically and to
avoid having to do a full re-keying each time the oMG moves into the area
served by a different authenticator.
• EAP Re-authentication Period : when 802.1x is used in a mobile
environment, it is recommended to set this to a large value in order to delay
the need for users to re-authenticate when a WAN connection is interrupted.
• Enable Cisco Legacy 802.1x Compatibility : enable for systems that use
lower case MAC addresses in the calling station ID field. This is advised for
interoperability with the Cisco RADIUS implementation.
• Authentication and Accounting Servers Configuration : two authentication
and two authentication servers can be set by typing in the host’s address and
port.
· Address : the IP address or host name to use for the server.
· Port : the port to use for the server.
· Secret : defines the shared secret between the oMG and the authenti-
cation server. If the specified secret is unknown to the authentication
server, it will ignore authentication requests from the oMG.
· Enabled : enabling this will enable the corresponding server.
A.7 LAN Throughput Settings
• Minimum Report Interval : the minimum time after which a throughput event
is generated. Events are not generated more often than this value. The
default is 60 seconds.