Sierra Wireless MP 700 Series, Справочник по командам

Страница: 86 / 118

MP 700 Series GPS AT Command Reference
84 2130309
+CNUM (continued) Retrieves the MSISDN from the SIM (continued)
<speed>
is the data rate as defined by the
+CBST
command. (See page 59.)
<service>
is the service related to the phone number:
•
0
Asynchronous modem
•
1
Synchronous modem
•
2
PAD access (asynchronous)
•
3
Packet access (synchronous)
•
4
Voice
•
5
Fax
<itc>
is the information transfer capability:
•
0
3.1 kHz
•
1
UDI (Unrestricted Digital Information transfer)
+COPN Read operator names
Returns the list of operator names from the modem. Each operator code that
has a corresponding name is returned.
Response parameters
The response to the +COPN command has these parameters:
+COPN: [<numeric1>],<alpha1>
[<CR><LF>+COPN: [<numeric2>],<alpha2>
[...]]
<numeric
n
>
is the operator in numeric format.
<alpha
n
>
is the operator in alphanumeric format.
+COPS=<mode>
[,<format>]
[,<operator>]
+COPS?
+COPS=?
Operator selection
+COPS=<mode>,<format>,<operator>
attempts a forced selection and
registration on the GSM network using a particular operator (i.e. GSM service
carrier).
<mode>
determines whether the selection is performed automatically by the
modem or is forced to the specific operator given in
<operator>
, using the
format specified in
<format>
. (The format setting is retained if the
+COPS?
command is reissued.) The selected <mode> applies to all further network
registrations (e.g. after
<mode>=2
, the modem is unregistered until
<mode>=0
or
1
is selected).
Note: Unless
<mode>=4
, if the selected operator is not available, no other
operator is selected.
Continued on next page.
Table 3-9: Command Reference Table (ASCII Alphabetic)
Command Description