Sierra Wireless MP 700 Series, Справочник по командам

Страница: 104 / 118

MP 700 Series GPS AT Command Reference
102 2130309
O[0]
The
0
parameter (
ATO0
)
is the only one permitted.
It is optional and has no
effect on the command.
Switch from command state to data state
Switches modem to from online command state to online data state. The
modem responds with the normal
CONNECT
response codes (if enabled) as if
the connection were new.
If the connection cannot be established, a
NO CARRIER
or
NO ANSWER
response results, as appropriate.
P
(ignored)
Pulse dialing
This command is provided for compatibility reasons; no action is taken by the
modem. Parameters are ignored.
Q[<n>]
Quiet—suppress result codes
Controls the return or suppression of result codes to the host computer. There
are two values for
<n>
:
•
0
: Result codes are returned from the modem. Default and recommended.
•
1
: Enable Quiet mode, suppressing result codes..
If
<n>=0
, the modem returns
OK
. If
<n>=1
, result codes are suppressed and
there is no response.
S<n>[=<x>]
S<n>?
S-Register Set/Query
Sets (or queries) the contents of the specified S-register
<n>
to the new value
<x>
. Zeros are assumed where parameter values are omitted.
Var. Range
<n>
Valid S-register number (See Table 3-10 on page 104 on page 104 for
values).
<x>
as determined by the S-register
<n>
.
T
(ignored)
Tone dialing
This command is provided for compatibility reasons; no action is taken by the
modem. Parameters are ignored.
V[<n>]
Verbose result code format
Specifies whether the modem displays the result codes in numeric format (non­
verbose) or as words (verbose). See page 106 for a numerical list of the result
codes.
Note: Numeric codes are returned as ASCII character numerals.
Continued on next page.
Table 3-9: Command Reference Table (ASCII Alphabetic)
Command Description