Rev 2 Jun.15
Proprietary and Confidential - Contents subject to change
9
2
2: Setup and Installation
Safe Handling Recommendations
Caution:
Handle the mangOH Development Board carefully to make sure components
are not accidentally damaged.
To help prevent accidental damage to the mangOH Development Board:
•
Hold the board by the edges (not touching the antenna ports or connectors)
to avoid possible ESD damage.
Figure 2-1: Handling the Board
•
Avoid touching the CF3 module sockets (J200, J600). The pins in these
sockets bend easily.
•
Mount the mangOH Development Board in a case, or attach standoffs (not
included) to the mounting holes at each corner of the board to avoid damage
to components on the bottom side of the board.
Initial Setup
To begin using the mangOH Development Board, set up your hardware and
software:
1.
Insert a CF3 form factor module in the primary socket. (See
2.
J600
J200
Mounting
holes
CF3 module
sockets