Sierra Wireless AirPrime WP75 Series, Справочник по командам AT

Страница: 119 / 300

Modem Status, Customization, and Reset Commands
Rev. 6 Oct.18 Proprietary and Confidential - Contents subject to change 119
+WEND
(notification)
Call end status—Unsolicited notification
Unsolicited notification received when a call or call attempt has ended.
To WEND (and other notifications), use AT+WUSLMSK. See
+WUSLMSK on
page 127 for details.
Notification format:
+WEND: <reason>,<service_option>,<RAT>
Examples:
•
Call originated using ATD1800555; on a GSM/WCDMA/LTE connection:
Notifications received:
+WORG: 1800555
+WCNT: 0,0
Call disconnected with ATH:
Notifications received:
+WEND: 29,0,0
This call ended with a normal release (<reason>=29)
•
Call originated using ATD18005551212; on a GSM/WCDMA/LTE connection:
Notifications received:
+WORG: 18005551212
+WEND: 22,0,0
This call failed because the signal faded (<reason>=22)
Parameters:
<reason> (Reason for end of call.)
•
For LTE:
•
ESM cause from the network, if available. For a list of ESM causes, refer to section
9.9.4.4 of 3GPP TS 24.301.
•
For non-LTE RATs:
•
0—Phone is offline
•
20—Phone is CDMA locked
•
21—Phone has no service
•
22—Call faded/dropped (CDMA only)
•
23—Received intercept from base station (CDMA only)
•
24—Received reorder from base station (CDMA only)
•
25—Received release from base station (normal call termination)
•
26—Service option rejected by base station (CDMA only)
•
27—Received incoming call
•
28—Received an alert stop from base station (CDMA only)
•
29—Software ended the call (normal release)
•
30—Received end activation (OTASP calls only)
•
31—Internal software aborted the origination/call (CDMA only)
•
32—Maximum access probes exhausted; the module failed to connect to the base
station (CDMA only)
•
33—Persistence test failure (CDMA only)
•
34—RUIM not present
•
35—Origination already in progress
•
36—General access failure
•
37—Received retry order (IS-2000 only)
•
38—Concurrent service not supported by base station
(Continued on next page)
Table 3-2: Modem Status Command Details (Continued)
Command Description