Sierra Wireless AirCard 755, Руководство по установке

Страница: 22 / 64

AirCard 755 Installation Guide
20 2130336
6. On the first window of the Found New Hardware Wizard,
select
Install the software automatically (Recommended)
and
click
Next
.
7. If the
Software Installation
window appears, you can safely
ignore the warning. Click
Continue Anyway
, each time it
appears.
8. Click
Finish
and repeat steps 6 to 8 as prompted.
9. When you see a window with the message “AirCard® has
been successfully installed.”, click
OK
.
Watcher should launch automatically when the AirCard is
inserted. If your AirCard has not yet been configured to use
your account, you are prompted to do so. See “Configuring
Your Account” on page 33.
To close the CD start-up menu, click
Demoshield
on the Taskbar,
then use the
exit
option in the lower right corner of the
window.
Installation on Windows NT
Note: The AirCard driver
requires that Windows
Networking is installed. Also
the PC Card slots must be
enabled. If you are not certain
that networking is installed
and the slots enabled, see the
Windows NT user documen-
tation for instructions. You
must be logged in with admin-
istrative privileges.
Note: You must re-install the Windows NT Service Pack after you
install the AirCard driver. Ensure you have your Service Pack CD
before you begin. (Version 6a is supported.)
Note: Windows system files may also be required to complete the
installation. These files are located on the Windows NT CD.
1. If the AirCard CD is not already in your CD-ROM drive,
insert it. The CD should autostart and display a menu.
· If the CD does not autostart, select
Start > Run
and enter
d:\launch.exe
where
d
is the drive letter of your CD-ROM
drive.
2. From the CD start-up menu, select
notebook installation and
documentation
and then
notebook software installation
to
launch the InstallShield Wizard.
3. Use the
Next
and
Back
buttons to navigate through the
wizard.
Using the default settings for the Destination Location and
Program Folder is recommended unless you have special
requirements and an advanced understanding of PC con-
figuration.
On completion of the software installation, exit from the
startup menu by clicking
exit
in the lower right corner.