TENSEGRITY 1 & 2
(FL & ELITE MODELS)
PITCHING INSTRUCTIONS
PACKAGE INCLUDES:
Tent Body with Attached Rain Fly, 1 Hooped Rear Pole, Guy Cords, Stakes, Pole/Stake Bag and Tent Stuff Sack
STEP 6:
Assemble rear pole. Insert into sleeve and
corner grommets. Stake out rear vent LineLoc
®
.
STEP 2:
Extend your trekking poles to the MAXIMUM
length. Insert trekking pole handles into corner
handle pocket. Angle poles so tips are even with grey
slotted webbing.
STEP 1:
Find an even piece of ground; be sure area
is clear of debris. Layout your tent as shown. Stake
the 4 corners (circled).
STEP 3:
Insert Grommet Tabs into slotted webbing closest to where trekking
pole tip extends. Insert trekking pole tip into grommet (it should fit securely.)
STEP 4:
Erect the tent by loosely staking out the
center loop of the gear closet panel. Note: this step
will help to make sure the large panel is centered.
STEP 5:
Completly LOOSEN the corner LineLoc
®
guy cord. Stake out the gear closet panel corners
evenly. Remove center loop stake from panel (Step 4)
Congratulations on the purchase of you new Sierra Designs Tent! In order to familiarize yourself with
your new tent, we recommend you “test pitch” it before embarking on your wilderness adventure.
Note: The colored bartacks along the slotted webbing will help you locate
the approximate pole tip location on each side. The cm listed above is the
approximate pole length.
STEP 7:
Evenly tighten front panel stake out
loops from Step 5 and your tent is setup.
120cm
140cm
130cm
130cm
140cm
120cm
Tensegrity tents were designed to save carry weight and require the use of trekking poles, which are not included.
Should you choose to forego trekking poles, you can order accessory poles (part #47154815) by calling 800.635.0461.
