Sienna SSP-4015, Инструкция по эксплуатации, Страница: 13 / 16

13
TROUBLESHOOTING
CAUTION: Prior to using or maintaining your steam press, isolate the unit
by removing the cord from the power socket.
PROBLEM SOLUTION
LED is not on
• Ensure press power cord is correctly plugged into a 120V
AC power outlet only.
• Ensure circuit breaker is operational.
• Try operating press from another power outlet.
No heat
• Make sure temperature has been selected.
• Pressing plate has been left in raised position for more than
20 minutes and automatic shut-off has engaged.
No steam
• Water may be low, re fi ll water tank.
• Temperature setting is too low to activate steam. Select
a higher temperature and wait for ready light to illuminate
before steaming.
Buttons are not working
properly
• Unplug the unit from the power outlet for 5 minutes then
plug back in.
E1 Warning
• The pressing plate and ironing board have been held
together for too long. Separate the plate from the board
and either unplug your unit then plug back in or turn the
press off then on again to restart the unit.
E2 Warning
• Automatic shut off feature warning. If the press is left for
too long unused, a beep and warning will appear. After 20
minutes of no use, the press will automatically shut off.
E3 Warning
•
There is a loose wire in the thermostat. Unplug your press
and call customer service.
Steam burst output is
weak
•
Pressing plate needs to be cleaned. Refer to cleaning section
of the manual for proper procedure.