6)
7)
8)
9)
10)
The amount of steam used when cleaning can be adjusted by turning adjustable steam dial (H)
to desired steam pressure. An arrow on the dial will indicate how much steam you are using.
A green refill light (M) indicator will illuminate when steamer is low on water, steamer will likely
stop emitting steam around this time. Simply press power on/off button (K) to turn off unit,
unplug, then wait for it to cool down a bit and refill the water tank with water.
NOTE: It is recommended that another high wattage appliance is not operated on the same circuit to
avoid a circuit overload.
WARNING: ON SURFACES THAT HAVE BEEN TREATED WITH WAX, THE WAX MAY BE REMOVED
BY THE HEAT AND STEAM ACTION. DO NOT USE ON UNSEALED WOOD FLOORS OR LET UNIT STAND
ON ANY WOOD FLOOR FOR AN EXTENDED PERIOD OF TIME. THIS MAY CAUSE THE WOOD GRAIN
TO RISE. IT IS RECOMMENDED THAT A SECTION BE TESTED IN AN ISOLATED AREA OF THE FLOOR.
IT IS ALSO RECOMMENDED THAT YOU CHECK THE USE AND CARE INSTRUCTIONS FOR CLEANING
FROM THE FLOOR MANUFACTURER TO ENSURE STEAM CLEANING IS ACCEPTABLE FOR YOUR WAXED
SURFACE.
Lay carpet glider (P) on the floor in an upright position with the rectangular flat surface facing
downward. Place steamer head(R)on top of glider.
IMPORTANT: The carpet glider is not designed to be fixed to the steamer head for safety reasons
including preventing burns. It is designed for use on soft carpet areas only, not for hard floor surfaces.
WARNING: NEVER RUN THE STEAMER WITHOUT WATER.
When you finish cleaning, unplug power cord from outlet then release pressure from steamer by
slowly turning water tank cap (I).
NOTE: Let the steamer cool down before releasing pressure from steamer. If you try to unscrew the
cap while still hot, it will burn you.
Be sure to empty water tank and carefully remove any accessories for drying.
CAUTION: The cloth pad may be very hot.
7
