en
Operating the appliance
20
If
œ©£
flashes in the display field before
the drying programme ends – high
temperature in the drum. The
programme for cooling the drum runs
until the temperature in the drum has
dropped.
After washing/drying
1.
Open the door and remove the
laundry.
2.
Turn the programme selector to
$
Off
. The appliance is switched off.
3.
Turn off the tap.
Not required for Aqua-Stop models.
4.
Disconnect the mains plug.
Notes
■
Do not leave any items of laundry in
the drum. In the next wash they may
shrink or discolour another item.
■
Remove any foreign objects from
the drum and the rubber seal – risk
of rust.
■
Leave the detergent drawer and
door open so that residual water can
evaporate.
■
Always remove the laundry.
■
Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for the unlocking device.
■
When the display panel has gone
out at the end of the programme,
energy-saving mode is active. To
activate the display again, select any
button.
