Siemens WTW87F90CH, Инструкция по установке и эксплуатации

Страница: 15 / 32

Programmes and buttons
en
15
Buttons
--------
Buttons Explanations and notes
Note: Not all buttons and their functions can be selected in all programmes.
E
push 3 sec.
( Press the Child-
proof lock for 3
sec. )
You can activate or deactivate the childproof lock by pressing and holding the child-
proof lock button for three seconds.
Q
60 min
(Anti-Crease
60 min.)
The drum moves the laundry at regular intervals after drying to prevent creasing. You
can extend the automatic Anti-Crease function by 60 minutes after any programme
has finished.
Q
120 min
(Anti-Crease
120 min.)
The drum moves the laundry at regular intervals after drying to prevent creasing. You
can extend the automatic Anti-Crease function by 120 minutes after any programme
has finished.
s
(Low-Heat Drying)
Reduced temperature for delicate fabrics, e.g. polyacrylic or elastane, may increase
the drying time.
C
(Audible signal) An audible signal sounds after the programme has ended.
5
(Dryness level) : Select the dryness level according to the laundry to be dried.
If you have selected a dryness level, this is stored for all programmes, except for Cot-
tons, even after the dryer has been switched off.
Ò
Cupboard Dry
Plus
Multi-layered, thick laundry that does not dry readily.
±
Cupboard Dry Normal, single-layered laundry.
ö
Iron Dry Normal, single-layered laundry that still needs to be damp after drying and is suitable
for ironing or hanging up.
ó
(Degree
of dryness)
If the laundry is too damp after drying, you can finely adjust the dryness levels e.g.
Cupboard Dry. The dryness level can be increased with the degree of dryness in
three stages, from
ˆ
to
ˆˆˆ
.
If you have adjusted the dryness level, the setting for all programmes with a selecta-
ble dryness level is retained even after the dryer is switched off.
–
3
+ (Ready in)
The programme will end in between 1 h and 24 h. Set the "Ready in" time in incre-
ments of one hour to delay the start of the programme. The required number of
hours after the programme ends is displayed on the display panel.
The drying time for timed programmes can be set to between 10 minutes and 3
hours and 30 minutes, in 10-minute increments.
A
Start Starts or pauses the programme.