Faults and what to do about them
en
37
3
Faults and what to do about them
Faults and what to do about them
Faults
Cause/remedy
Please empty
the condensate con-
tainer
on the display
panel and the drying
cycle is interrupted.
■
Empty the condensate container; and the dryer; .
■
If the optional condensation drain* is installed, the drain hose may be
blocked or kinked. Check the hose for deposits and rinse the hose. Lay
the hose without any kinks.
Please clean the fluff
filters
on the display
panel.
Clean the fluff filter and press the Start button
.
Heat exchanger is
being rinsed
on
the display panel.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out
the condensate container while this is displayed.
Dryer does not start.
■
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay
Creasing.
■
Creasing occurs when you have exceeded the maximum load or selected
the wrong programme for the type of fabric. All the required information
can be found in the programme table
■
Remove clothes immediately after drying; creasing may occur if they are
left in the drum.
Water is leaking out.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Change in the pro-
gramme duration dis-
played during drying.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
* depending on the model
